CeskaZbrojovka CZ75, 85

Grip parameters

The necessary information for your grip are requested here step by step:
If you are unsure about this, you can upload a outline sketch of your hand in the last step!

Size (required)

Width of the hand measured across the finger base joints.
If you are between two sizes, choose the larger one!
Hand width

Side (required)

Right handed grip

Left handed grip

Form (required)

Convex form for normal hands,
flat form for short or strong hands.

As "normal" we call hands where the hand has the same width than the length of the middle finger.
E.g. a 95mm wide hand with a 90mm long middle finger, we would call "short"!
Hand length

convex

flat

Angle (required)

0° lateral turning for a normal hand and head position so that the barrel axis points straight into the arm,

7° lateral turning for a cross-dominant target eye, short hands (better reachability of the trigger) or an inward pulling front sight (to the left for right-handers).

0°

7°

Volume (required)

Normal volume for normal hands,
thick volume (+5mm) for long hands.

As "long" we call hands where the middle finger is longer than the widht of the hand.
E.g. a 95mm wide hand with a 100mm long middle finger, we would call "long"!
Hand length

normal

thick

Palm rest (required)

normal form, for air / sport pistol

upswept at the back, for US bullseye

€40.80**

Comments

Here you can enter comments about the order:

Hand sketch

If you are unsure about the selection of the grip parameters, you are welcome to upload a hand outline sketch with the order:

Please place your shooting hand on a sheet of paper, as shown on this sketch.
Draw with a thin ballpoint pen around the hand contour.
Make two reference lines, each 10cm long, horizontal and vertical on the sheet. The start and end points must be clearly visible!
Scan the sketch or photograph it vertically from above.

> More infos

Drag & drop files (JPG, GIF, PNG...) here (Max. 1 file(s), max. 10 MB per file)

Grip parameters